First, the installation of binding equipment and skills
1, the installation of the handle: the handle fitted with the box set into the binding machine on the right side of the square shaft position (note: handle working angle), with the locking screw tightened.
 2, the amount of paper: must be based on the individual model instructions to determine the amount of paper, not excessive. Otherwise it may lead to the following undesirable situations:
       ① handle can not be pressed, through the paper obstacles, can not penetrate.
       ② uneven margins, prone to paper edge roll corner.        ③ Causes the square shaft to be twisted, resulting in the shortening of the service life of the binding machine.
3, the paper margin adjustment, the principle is: according to the diameter of the pull ring to determine the size of the margin. The method is: with the adjusting screw (installed in the back of the binding machine) to adjust the scale to achieve the purpose of the margin. The rules are: pull the ring diameter, paper margin adjustment, pull the ring diameter is small, paper margin adjustment is small.
4, punching operation method:
       ① the paper will be neatly organized, close to the positioning block, the paper will be fed into the machine parallel to the top in place until.
       ② left hand pressure on the paper, the right hand holding the handle, press down to the blade through the paper, and then lift the handle.
        ③ hands smoothly will hit the paper out, such as the phenomenon of hanging paper, repeat the handle to press down, and then lift up in place can be taken out of the paper.
5, pull the circle binding method:
        According to the number of papers, select the size of different specifications of the pull ring, the handle slowly push up to the pull ring to open, and then insert the paper hole into the pull ring, pull back the handle slowly, so that all the teeth of the pull ring inserted into the paper hole, pull the handle into place, tighten the pull ring mouth, the binding book is loaded.
Second, the binding method
Binding, the pressure foot handwheel in a clockwise direction to raise the pressure foot, the binding material into the pressure foot under the selected position to release the pressure foot handwheel automatically pressed, and then the pressure foot handwheel to the counterclockwise direction ~ 180 ° or so after locking, and then turn the staple pin handle to the counterclockwise direction, the staple pin through the material. When the penetration in place, the lead arm will automatically hang the line in the staple hook line groove, at this time to lift the handle upward, in the staple exit at the same time, the binding line will be followed through the binding material, to the clockwise direction of the release of the presser foot handwheel, to complete the binding of a needle, repeat the above procedures, and immediately can be completed the task of binding.
Third, on the needle method
       Loosen the fastening screws on the buckle needle device, remove the buckle needle device, the tail of the staple hook into the staple fixing hole, to maintain vertical, the buckle needle into the original position of the staple bar, the fastening screws on the buckle needle device top tight.

E-mail:
sales-001@bsdmachinery.cn

Tel/WhatsApp:
+8613665882396

Address:No. 99 Jinxiu Road, Economic Development Zone, Lanxi City, Zhejiang Province